Description
AAT-210 Standard Floor Covering Adhesive is a 0 VOC, non-staining, latex-based adhesive, designed for the installation of glue-down carpets and resilient sheet goods. This non-flammable adhesive is protected by the CleanGuard® two-stage antimicrobial. CleanGuard® is a specifically formulated broad-spectrum, anti-microbial agent that protects our adhesives and sealers from microorganisms, such as mold or mildew, in both the wet and dry state.
AAT-210 is recommended for use with the following carpet backings: woven polypropylene (ActionBac®), polyurethane foam, jute, rubber, and needlepunch. Due to its non-staining formula, AAT-210 can be used to install felt-backed sheet vinyl. NOTE: This adhesive is not recommended for pure vinyl backed sheet goods or carpets.
Sub-floors must be flat and structurally sound. The sub-floor should be flat within 3/16” in 10’ or 1/8” in 6’. All paint, varnish, oil, wax, finishes and any other bond inhibiting substances must be removed. Smooth or glazed surfaces must be abraded. Repair all joints and cracks with latex-fortified portland cement underlayment. Concrete sub-floors must be properly prepared according to the recommended practices detailed in the document ASTM F- 710-11. Never sand existing resilient flooring that could contain asbestos. Follow all Federal, State and Local regulations relating to the removal of in-place, asbestos containing material. Very porous sub-floors must be primed with AAT-570 Primer/Sealer.
Specs/MSDS: http://www.aatglue.com/210-Standard-Floor-Covering-Adhesive.html